1. First page
  2. Documentation
  3. Administration Manual
  4. Configuring Application Services
  5. Connecting services with database

Connecting services with database

After installing the application services, start the program via elevated Command Prompt with the command:

"C:\Program Files\EBAAutomation_\bin\ebaservicesettings.exe" -local -home "service_name"

Fill in the route and service name you specified at the time of installation.

Later, you can run the program using a shortcut from the Start menu, or via the EBA services monitor, or create a shortcut using the above command.

When the new installation is first started, the program will show us a window for setting up the database connection – the same one we have prepared for using EBA DMS.

Figure 1: Database connection setup pop-up window

Enter the required parameters, before confirming you can test the connection by clicking on the Test connection button.

Figure 2: Database connection set up

After setting up the database connection, close the Control Center and reopen it – this saves the settings and starts the service setup.

Change the database connection details

In case you need to change the database connection data – e.g. in case of migration of a server with a database, the parameters are set in Control Center in the Database tab.

Figure 3: Database settings tab in Control Centre

How can we help?